Evil-Mochi
Firmware v1 · ESP32-C3

Firmware installer

Flash the latest Evil-Mochi firmware directly from this page. No drivers and no command-line tools are required.

Web Serial is not supported in this browser. Use Chrome, Edge, or Opera on desktop. Serial access is blocked. Open this page over HTTPS and allow serial access when prompted.

Requires a Chromium-based browser on desktop (Chrome, Edge, or Opera).

Installation stepsprocedure
  1. Connect the device to your computer with a data-capable USB cable.
  2. Enter bootloader mode if the device does not appear in the port list: hold BOOT, press RESET, then release BOOT.
  3. Click Install firmware and select the serial port for your device.
  4. Wait for the process to finish. Do not disconnect the device during flashing.
  5. Reset the device after installation completes to boot into Evil-Mochi.